This topic has been closed by the administrator. Comments are no longer accepted.
I have a commercial application where a standing seam metal roof (seams continue down panel sides). Do you have a detail for connecting gutters to the standing seams? I need a plate system to run the drainage from the metal roof surface to the gutter.
Or copy this URL:
https://www.metalroofing.com/spirit/comment/10452/find/
If I understand this right you want to extend the standing seam panel down the fascia. In order for the gutter to function properly, you must terminate the roof panel at the fascia turndown. See this detail: http://www.archmetalroof.com/products/structural/200_series/details/J2-6-EAVE_W_STD_GUTTER_Model_(1).pdf
The angle that the gutter fasteners to should be 22 GA or thicker.
Brian Selig Architectural Building Components Metal Roof and Wall Panels
10/29/2007
Share
Or copy this URL:
https://www.metalroofing.com/spirit/comment/10453/find/
This is perfect, just what I was looking for. Thank you very much. What spacing would you recommend for the anchors? What type of anchors would you recommend connection the metal wall panels and roof panels?
10/29/2007
Or copy this URL: https://www.metalroofing.com/spirit/comment/10452/find/Architectural Building Components Metal Roof and Wall Panels
10/29/2007
Or copy this URL: https://www.metalroofing.com/spirit/comment/10453/find/10/29/2007
Or copy this URL: https://www.metalroofing.com/spirit/comment/10454/find/