Or copy this URL:
https://www.metalroofing.com/spirit/comment/4302/find/
I am assuming this is an "up and over" sort of convex curve and not a "round" roof or a concave curve.
Generally, for a convex curve, some of the horizontally-run "shingle-style" panels will work very well.
For vertical seam panels, there is not a lot of ability to curve them on the job though some vertical panels are available pre-curved from the factory.
Generally, the less configured vertical panels are easier to curve but, again, there are pretty strong restrictions on how much you can do with them.
I would suggest contacting manufacturers of products you might like and sending them picture sor drawings of the roof. I would sure take a hard look at the horizontally-run products though for this type of application.
10/13/2004
Or copy this URL: https://www.metalroofing.com/spirit/comment/4302/find/10/13/2004
Or copy this URL: https://www.metalroofing.com/spirit/comment/4303/find/