This topic has been closed by the administrator. Comments are no longer accepted.
My contactor suggests a handmade copper shingled roof.
What is the minumum roof pitch for hand made copper shingles with 180 bend out two sides, & 180 bend other two sides by smacna standards?
Thanks
Mike
Or copy this URL:
https://www.metalroofing.com/spirit/comment/2757/find/
Unless you are going to solder the seams, I would not go less than 3:12. There are, by the way, pre-formed copper shingles which can be used down to 3:12. If the seams will be soldered, you could probably go as low as 2:12 or perhaps 1-1/2:12.
Good luck.
2/19/2004
Isaiah Industries, Inc.
2/20/2004