i have a metal roof with very little picth it was put on my addition on the back of my house trailer so the metal was put over the shingels on the exsiting trailer roof but not all the way to the peak because of the vents on the trailer roof then there is flashing the metal goes under the flashing then down over the tar paper ond OSB on the new part it was screwed down in the flats of the metal. my problem is this i have water running down the inside of my outside wall when the snow starts to melt and in the windows how do i fix this?
Guest User
2007-03-04 10:19:53.000000
i had my brother build this and no i have not contacted the manufacturer. we are at a lose as to why it is leaking if you could give us some clue as where to start to fix it it is a 12 / 2 picth and is the fact that it was screwed down in the flats a problem?
Guest User
2007-03-06 10:33:47.000000
It sounds to me like the metal roofing has been used on a lower pitch than it should have been. Have you contacted the manufacturer?
Todd Miller
2007-03-05 22:09:31.000000
Send me pictures if you wish -- tmiller@classicroof.com
I would still contact the roofing manufacturer though.
The problem may very well be somewhere up at the top of the panels.
Also, for a 2:12 pitch there maybe should have been sealant in the panel laps. Again, the manufacturer should be consulted.
